2322
Please note:
Supported image formats are: JPEG, GIF, PNG, BMP and WebP.
8.4 Standby Screen
8.4.1 Make the Screen sleep during Standby.
Please note:
This option is congured by default.
1. From the Home Screen, touch the Settings button.
2. Touch the Display, Wallpaper & Sounds menu item.
3. Touch the Standby Screen menu item.
4. Touch the Sleep standby item.
8.4.2 Show a Photo Slideshow during Standby.
Please note:
You must select more than one image when using this feature to prevent long-term
damage to the LCD screen.
1. From the Home Screen, touch the Settings button.
2. Touch the Display, Wallpaper & Sounds menu item.
3. Touch the Standby Screen menu item.
4. Touch the Photo Slideshow Settings menu item.
5. Touch the [+] button at the right of the screen title bar.
6. If you would like to select any of the default photos, touch the Default Photos menu
item and skip to step 8.
7. If you would like to select your own photos, insert a Micro SD card into the Micro SD
slot on the TouchOne as described in Figure 4.
8. Touch the thumbnail of the desired slideshow images. A tick icon will be displayed on
each thumbnail that is selected.
Please note:
Supported image formats are: JPEG, GIF, PNG, BMP and WebP.
8.4.3 Change the Standby Time
The Standby time is the length of time from the last touch on the screen until the
selection Standby option (Sleep or Photo Slideshow) is displayed.
1. From the Home Screen, touch the Settings button.
2. Touch the Display, Wallpaper & Sounds menu item.
3. Touch the Standby Screen menu item.
4. Slide the Standby Time left or right to the desired Standby Time.
8.4.4 Enable Standby when the system is armed in AWAY Mode
Be default, the Standby screen will only display when the system is disarmed or
armed is STAY Mode so the alarm status is always visible when the system is armed in
AWAY Mode. You can change this behaviour by following the steps below.
To Next Page
Loading...
