98
Entry Guard Timer for STAY Mode 2
When arming the system in STAY Mode 2, an optional entry timer called Entry Guard
Time for STAY Mode is available. Use this entry timer to delay the sirens if a zone is
not automatically isolated and activated into alarm condition.
Entry Guard Time for STAY Mode is the delay time used for all zones except 24-hour
zones when the system is armed in STAY Mode 1 or STAY Mode 2.
If the Entry Guard Time for STAY Mode is programmed and a zone that was not
automatically isolated is activated, the TouchOne beeps twice per second until the
entry timer expires or the system is disarmed. If the alarm condition is not reset by
entering your user code (such as [2580]) before the entry time expires, the sirens
activate into alarm. Only your installer can program this feature.
How to Arm the System in STAY Mode 2
Touch the Keypad button to show the Keypad screen.
Hold down the [0] button until two beeps sound. Then the Home Screen will be
displayed and the Area Card Status will change.
At the end of Exit Time, the TouchOne emits one short beep.
2.3.4 Disarming the System
When you enter the premises after the system is armed in AWAY mode, or if you
armed the system in STAY Mode 1 or STAY Mode 2, you must disarm the system to
disable detection devices that activate an alarm.
If there was an alarm condition prior to disarming the system, the Activation Keypad
screen will display. Once you have disarmed the system, the System Status Button will
scroll through the zones that activated. To view more detail, touch the System Status
Button to open the System Status screen.
How to Disarm the System
If the Keypad Dialog is not automatically displayed, you must touch the Disarm Area
button before proceeding to the next step.
Enter your user code (for example, [2580]).
Two beeps will sound to conrm the system has disarmed.
If you make a mistake when entering your user code, touch the [<] button and try step
2 again.
To Next Page
Loading...
