Bosch VIA - Page 36

MD deck operation
About system constraints
The MiniDisc (MD) system uses a different method for recording
than traditional cassettes and DATs.
Therefore, there are some system limitations, and
the following symptoms may occur. Please note
that these are not malfunctions.
"Disc Full” is displayed even if the maximum recording time has nat been
reached
With the MD system, "Disc Full" will be displayed when the
number of songs is full, regardless of the time. You cannot
record more than 255 songs. To add more songs, either delete the
unnecessary songs or record them on a second disc.
"Disc Full” is displayed even though there is sufficient number of songs and
recording time,
Ifemphasis information, etc. is turned on and off a lot during a song, it
will be treated as a break in the song, and the message < "Disc Full" wil appear
regardless of the time or number of songs.
‘*The remaining time on the disc does not increase no matter how many
short songs | delete. When displaying the remaining time on a disc, portions
of 8 seconds or less are ignored, so even if you delete a short song, the time
may not be added.
@ 't may not be possible to connect.
Songs created through editing may not be able to be
connected,
The total time recorded on the disc and the remaining time may
not match the maximum recordable time.
Usually one cluster (approximately 2 seconds) is recorded in minimum
units. Anything less than that will still take up 2 seconds of
space. This reduces the amount of time that can actually be
used. Additionally, if there is a scratch on the disc, the scratched part
will be automatically deleted, saving you time.
When searching for a song that has been edited, the sound may be
interrupted
Track numbers may not be assigned accurately.
When recording a CD using a digital connection, short songs may be created
depending on the recorded content of the CD.
Also, when track marking is performed automatically using the auto
mark function, the track number may not be assigned accurately depending
on the content of what is being recorded.
@ The "TOC Reading’ display does not disappear easily.
When you insert a newly purchased recording disc, the "TOC
Reading” display will appear longer than usual
About serial copy management system
Serial Copy Management System (SCMS) is a regulation that limits digital recording between various audio devices
to only one generation for copyright
protection.- Digital recording from CD (compact disc), DAT (digital audio tape), MD (mini disc) software to MD
However, once a digital signal has been recorded as a digital signal on an MD, it cannot be recorded as a digital signal on
another MD.
= = =;
- You can record analog records, FM broadcasts, etc. from an MD recorded with this unit to another MD as a digital signal, but once you have
recorded a digital signal from an MD as a digital signal, you cannot transfer the digital signal to another MD. You cannot record directly