22
Creating Loop Phrases by Recording Audio from a CD/Digital Audio Player
8.
When you are finished with playback, press
the pedal twice.
*
Be sure to press the pedal two times within an interval of one second.
* For more details on saving, refer to “Saving Phrases
(WRITE)” (p. 32).
Be sure to connect the CD or digital audio player to the
AUX IN jack. If anything is connected to the INPUT
jack, no signals from AUX IN will be recorded.
With the factory settings, the RC-2 applies compensa-
tion to the AUX IN signal so that it sounds appropriate
when played through a typical guitar amp.
When sound that's been recorded from a CD, digital au-
dio player, or similar source is played through a guitar
amp, the midrange and high-frequency range of the
sound tend to be emphasized.
If you wish to record the AUX IN signal without the
compensation applied, you can defeat it using the fol-
lowing procedure.
Defeating AUX IN Compensation
1.
Set the MODE knob to .
2.
Hold down the SELECT/ENTER button and
turn on the power to the RC-2.
3.
Confirm that the LOOP/ONE SHOT indicator
is lit (green), the CHECK indicator is lit (red),
the REC/PLAY/DUB indicator is lit (green),
then release the pedal.
After the pedal is released, only the CHECK indicator
will remain lit (red).
* This status is cancelled when the power is turned off; the
next time the power is switched on, AUX IN compensation
is enabled.
<CAUTION>
• Unauthorized recording, distribution, sale, lending, public performance, broadcasting, or the like, in whole or in
part, of a work (musical composition, video, broadcast, public performance, or the like) whose copyright is held
by a third party is prohibited by law.
• Do not use this unit for purposes that could infringe on a copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party copyrights arising through your use of this unit.
RC-2_e.book 22 ページ ２００６年１０月２７日 金曜日 午前１０時３１分
To Next Page
Loading...
Need help?
General
