35
About the Tempo and Time Signature
Setting the Tempo
When you wish to record to an empty phrase track, you can
set the tempo before recording.
You can also change the playback tempo when playing back
saved phrase tracks.
* If you save a phrase after changing the playback tempo, the
phrase is then saved with the modified tempo. If you do not
save it, the tempo change will be lost.
1.
Turn the PHRASE SELECT knob to select
the phrase track you wish to use.
2.
Set the MODE knob to .
3.
Press the TAP TEMPO button several times
at the desired tempo.
The tempo will be set according to the intervals at which
you press the button.
* The tempo can be changed only within a limited ratio.
* You cannot set the tempo for phrases that are looped over an
interval shorter than the minimum recording time (approxi-
mately 1.5 seconds).
* If you wish to record a new phrase at the same tempo as the
previously selected phrase, press the TAP TEMPO button
once.
* You can create a loop phrase with the Loop Quantize
function disabled by starting recording without setting the
tempo.
You can only change the playback tempo of phrases
saved to the phrase tracks. To change the playback tem-
po of a phrase stored in temporary memory immediate-
ly following overdubbing or recording, save it to a
phrase track (p. 32).
1
2
3
RC-2_e.book 35 ページ ２００６年１０月２７日 金曜日 午前１０時３１分
To Next Page
Loading...
Need help?
General
