39
Troubleshooting
Power does not turn on/CHECK indicator
does not light
• Is the correct AC adaptor (PSA-series; sold separately)
properly connected?
Check once more to confirm the adaptor is connected (p. 10).
* Never use any AC adaptor other than the adaptor specified.
• Has the battery run down?
Replace with a new battery (p. 38).
* The battery included with the RC-2 is intended only for
confirming that the unit is functional.
* This unit consumes a large amount of current, so the use of
an AC adaptor is recommended. If using a battery, use an
alkaline type battery.
* To reduce battery consumption, be sure to disconnect the
plug connected to the OUTPUT jack whenever the unit is
not in use (p. 10).
• Is the plug properly connected to the OUTPUT jack?
Check the connection once again (p. 10).
* The power will not turn on without a plug connected to the
OUTPUT jack.
No sound/not loud enough
• The recorded or overdubbed sound cannot be heard or
is too quiet
Use the PHRASE LEVEL knob to adjust the volume.
• Could you be using a connection cable that contains a
resistor?
Use a connection cable that does not contain a resistor.
Guide sound cannot be heard/is not loud
enough
• Use the GUIDE LEVEL knob to adjust the volume.
• The guide tone plays under the following
circumstances:
• When the tempo is set before recording
• During playback of a phrase
Recording/overdubbing ends while still
in progress
• There is insufficient memory. Delete unneeded phrases (p.
33), then perform the recording or overdubbing once again.
Recording does not end immediately
when you press the pedal
• Since the phrase length is adjusted automatically when
you record with Loop Quantize or record a phrase that
is shorter than the minimum recording time
(approximately 1.5 seconds), recording may not stop
immediately after you press the pedal.
Recording begins immediately even
though MODE is set to AUTO
• If due to distortion or other causes there is a significant
amount of noise, that noise may be enough to trigger
the beginning of recording. Reduce the noise, for
example by lowering the distortion level.
RC-2_e.book 39 ページ ２００６年１０月２７日 金曜日 午前１０時３１分
To Next Page
Loading...
Need help?
General
