Bostitch 650S5 - Directional Exhaust; Quick Release Magazine; Accessories

-11-
DIRECTIONAL EXHAUST DEFLECTOR
Loosen screw as shown. Adjust to desired exhaust direction
and tighten screw.
ACCESSORIES AVAILABLE
BC601 4 oz. Stanley-Bostitch Air -Tool Lubricant
BC602 1 pint Stanley-Bostitch Air -Tool Lubricant
BC603 1 pint Stanley-Bostitch “Winter-Formula” Air-Tool Lubricant
BC604 1 quart Stanley-Bostitch Air -Tool Lubricant
86524 4 oz. tube O-Ring lube.
851325 LOCTITE Grade 271 (.02 oz.)
851385 LOCTITE Grade 242 (.02 oz.)
N80K2 Remote Control Kit
107205 Kit Weight Attachment 700/800
107306 Kit Weight Attachment 650
107290 Arm, Wrap Around CT 800
107596 Arm, Wrap Around CT 750
108551 Assembly, Vinyl Siding Trip 650
108072 Kit, Long Magazine 650S4
108073 Kit, Long Magazine 650S5
108074 Kit, Long Magazine 750S4
108075 Kit, Long Magazine 750S5
108076 Kit, Long Magazine 850S4
108077 Kit, Long Magazine 863S4
RECOMMENDED TOOLS
1 10mm Nut Driver
1 5mm Allen Wrench
1 4mm Allen Wrench
1 2.77mm (.109”) diameter Pin Punch
1 5.56mm (.219”) diameter Pin Punch
1 Hammer
1 Small Straight Blade Screw Driver
The 600,700 & 800 series staplers contain a Quick Release Magazine feature. The magazine is
spring loaded to reduce jamming. When a jam does occur, a quick release mechanism at the rear
of the magazine allows the magazine to move back, in order to clear the jam.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
If a jam does occur, locate the latch at the rear of the magazine (fig.1). Pull down on the latch to
open (fig.2), and rotate it clockwise 1/4 turn (fig.3). Pull back on the latch (fig.4). This will pull the
magazine back to clear the jam. After removing the jammed fastener, push on the latch, rotate it
1/4 turn counterclockwise and push up to close.
QUICK RELEASE MAGAZINE
FIG. 1
FIG. 2
FIG.3 FIG.4
OPEN
ROTATE
PULL
LATCH