BÖWE M18 - Program Sequences (Extract)

57
M12/M15/M18
9. Control System and Programs 9.
9.2 Program Sequences (Extract) 9.2
Machine M12/M15 /M18 P 01 P 02 P 03 P 04 P 05 P 06 P 07 P 08
Pump tank to tank 00:30 00:30 00:30 00:40 00:40 00:30 00:40
Pump up from tank 1 01:30 01:00 01:00 01:00 01:00 01:00
Pump out extraction tank 00:30 00:30 00:30 00:30 00:30 00:30 00:30
Pump up from tank 2 01:00 00:30 01:15
Pump circuit 02:00 02:00 02:00 03:00 02:00
Spin to distillation 01:45 01:45 01:45 01:45 05:15
Pump to distillation 00:30 00:30 00:30 00:30
Pump up from tank 1 01:30 01:30
Pump up from tank 2 01:00 01:00 02:30 01:10*
Filtration 05:00 05:00 05:00 05:00 05:00
Pump circuit 03.00* 03.00* 03.00* 03.00* 03.00* 04:00
Pump to tank 1 01:30 01:30 01:30 01:30 01:30
Pump to tank 2
Pump to distillation 00:30
Spin to tank 1 05:15 05:15
Spin to tank 2
Spin to distillation 05:15 02:45 05:15 05:15
Pump to tank 1 00:30 00:30
Pump to tank 2
Pump to distillation 00:30 00:30 00:30 00:30
Pump up from tank 2 01:10
Pump circuit 02:00
Pump to tank 1
Pump to distillation
Spin to tank 1 05:15
Spin to distillation
Pump to tank 1 00:30
Tumble 00:30 00:30 00:30 00:30 00:30 00:30 00:30 00:30
Spray XX XX
Tumble 04:00 04:00
Predrying without heat: 03:00 03:00
Dry, cage outlet
50°C/122°F
Dry, cage inlet: 75°C
/167°F ***
12:00 12:00 12:00 12:00 12:00 12:00 14:00 14:00
Drying time controller X X X X X X X X
Reduction** from
until
02:00
06:00
02:00
06:00
02:00
06:00
02:00
06:00
02:00
06:00
02:00
06:00
02:00
06:00
02:00
06:00
* Dosing
** Temperature controlled
*** Depends on used solvent; at P04 /P05: 70 °C /161°F
X Plus standstill times because of the drying controller
xx Depends on the spraying time specified
The times given above correspond to the program sequences at the time of printing.
We reserve the right to make any procedural changes to times and program sequences in the interest of technical progress.