BÖWE M18 - Maintenance; Operation and Maintenance Summary

66
M12/M15/M18
11. Maintenance 11.
Attention:
Warranty claims will only be accepted if maintenance has been performed
properly! Follow safety regulations! All recommendations concerning
maintenance are minimum requirements
and refer to a one-shift operation!
11.1 Operation and Maintenance Summary 11.1
When starting operation:
Weekly:
 Run multi-maintenance program P49 or run  Turn on steam supply
 Turn on room ventilation system alternative P46, P54 and P45
 Turn on cooling water supply
 Turn on compressed air supply
 Clean the sprayer dirt strainers and
spray nozzles
 Open condensate valve
 Turn on machine main switch
 Check limit switch function
 Start deodorizing program P43, press "STOP"
button when program ends and
signal sounds.
 Unbalance switch: Visual inspection for
damage. Check the central position of the
feeler in the Bore.
Monthly:
When stopping operation:
 Execute multi-maintenance program P50
 Turn off machine main switch  Check solvent levels in the tanks
 Turn off steam supply
 Close condensate valve
 Clean strainers in water and steam feeders
 Lubricate cage bearing
 Turn off cooling water supply
 Turn off compressed air supply to compressor
 Turn off room ventilation system or switch to
night operation
Semi-annually:
 Have the flash point of the solvent checked
Inspection and maintenance work:
 Check air cooler, clean
Daily:
(before starting the first cycle)
 Clean tanks
 Check machine for leaks  Retighten screwed unions
 Check solvent safety trough for solvent  Check V-belt tension, re-tension
 Drain water from compressed air armature
 Clean button trap strainer and lint filter (see
11.5.1)
Annually:
 Dispose of process water in accordance with
the regulations that apply in your country!
 Machine inspection (according to
BGR 500 chapter 2.14)
 Check the liquid level of the cleaning agent
container
 Remove filter discs and clean in the
machine (program P6)
 Check back wall of cage, clean  Machine is ready for operation
Daily:
(after the last cycle)
 Execute distillation maintenance program P45
Attention:
 Immediately close the loading door
and maintenance openings again.
(Alternatively start with 15 E during the last
charge)
 Use only lithium-based lubricating
greases, such as.
- ALVANIA 3 (SHELL) - MARSON L2 (FINA)
- BEACON 2 (ESSO) - LGMT 3 (SKF)