19
TROUBLE PROBABLE CAUSE REMEDY
F
Hoist chatters while raising rated
load.
1. Same as D2.
2. Hydraulic oil ow to motor may be
too low.
3. Controls being operated too quick-
ly.
Same as remedies for Trouble D2.
Same as remedies for Trouble E2.
Conduct operator training as re-
quired.
G
The wire rope does not spool
smoothly on the drum.
1. The hoist may be mounted too
close to the main sheave, causing
the eet angle to be more than 1.5
degrees.
2. The hoist may not be mounted per-
pendicular to an imaginary line be-
tween the center of the cable drum
and the rst sheave.
3. Could possibly be using the wrong
lay rope. There is a distinct advan-
tage in applying rope of the proper
direction of lay. When the load is
slacked o, the several coils on the
drum will stay closer together and
maintain an even layer. If rope of
improper lay is used, the coils will
spread apart each time the load is
removed. Then, when winding is
resumed, the rope has a tendency
to crisscross and overlap on the
drum. The result is apt to be a at-
tened and crushed rope.
4. The hoist may have been over-
loaded, causing permanent set in
the wire rope.
Check mounting distance and eet
angle. Reposition hoist as required.
Refer to Hoist Installation section of
manual.
Consult wire rope manufacturer for
recommendation of wire rope that
best suits your application.
Replace wire rope and conduct op-
erator/rigger training as required.
To Next Page
Loading...
