To Next PageTo Next Page
Need help?Do you have a question about the BRADEN CH175A and is the answer not in the manual?
Defines the meaning of WARNING and CAUTION emblems used in the manual.
Details requirements for mounting the hoist horizontally and securely.
Provides instructions and warnings for installing wire rope securely.
Covers checking and changing the gear oil level and frequency.
Recommends a warm-up procedure for the winch, especially in cold temperatures.
Explains the importance of using the correct gear oil and provides recommendations.
Addresses issues with the pilot orifice, brake cylinder, or brake discs.
Covers issues like high back pressure, worn brake discs, or slipping brake clutch.
Explains causes like improper mounting, binding, or low relief valve pressure.
Covers causes like high hydraulic temperatures, plugged heat exchanger, or worn parts.
Instructions for removing the brake clutch and primary sun gear.
Instructions for removing planet carrier assemblies and gears.
Steps for compressing the backup plate to remove the retaining ring.
Details on inspecting the brake cylinder for damage and O-ring grooves.
Steps for lubricating and installing O-rings and backup rings on the piston.
Steps for compressing springs and installing the retaining ring.
Procedure for pressure testing the assembled brake cylinder.
Steps to drive out spiral pins and remove planet gears and bearings.
Guidelines for inspecting bearings, cages, and gears for wear or damage.
Steps for installing bearings, thrust washers, and shafts into the carrier.
Steps for removing the snap ring and sprag bushing retainer.
Procedures for cleaning and inspecting spool, piston, and valve housing.
General
