_______________________________________________________________________
Getting Started 7
♦♦ Getting Started
2.0 Introduction
This chapter will assist you in unpacking, configuring the communications,
connecting your Printer, loading media stock, and installing the ribbon.
2.1 Unpacking
Inspect the shipping container(s) for signs of shipment damage. If damage is
evident, contact the carrier directly to specify the nature and extent of the
damage.
The printer is packed in molded styrofoam packaging. The Printer is enclosed
in a plastic bag to reduce the chance of moisture damage during shipment.
Remove the Printer from the plastic bag.
In addition to this manual, the shipping container(s) should include the
following standard items:
• Label printer
• AC power cord
• Special or additional items purchased.
To Next Page
Loading...
Need help?
General
