_____________________________________________________________________________________________________
Maintenance and Adjustments 51
♦♦ Maintenance and Adjustments
5.0 Introduction
This chapter contains information about maintaining your Printer,
troubleshooting tips, solutions, and Printer adjustment information.
5.1 Printer Maintenance schedules
If your Printer is equipped with an optional Rotary Cutter, it is recommended
that the cutter's blades are cleaned every 25,000 cuts. The blades in the Rotary
Cutter, although reversible, can not be sharpened and must be replaced if they
become dull.
The Media Path and Printhead should be cleaned each time a new roll of media
is installed in the Printer.
The Tear Bar can become gummed up from the media backing. The Tear Bar
should be cleaned with Isopropyl Alcohol when build-up is noticeable.
To Next Page
Loading...
