IMPORTANT SAFETY INSTRUCTIONS
Your Bar Code Printer has been designed to give you many years of safe,
reliable service. As with all electrical equipment, there are a few basic
precautions you should take to avoid getting hurt or damaging the Printer.
• Carefully read the installation and operating instructions provided
with your Printer.
• Read and follow all warning instruction labels on the Printer itself.
• Place the Printer on a flat, firm, solid surface.
• To protect your Printer from overheating, make sure all openings on
the Printer are not blocked.
• Do not place the Printer on or near a heat source, (i.e., a radiator or
heat register).
• Do not use your Printer near water, or spill liquid of any kind into it.
• Be certain that your power source matches the rating listed on the back
of the Printer. If you are unsure, check with your dealer or with your
local power company.
• As a safety device, your Printer has a grounded, 3-prong plug that will
only fit into a grounded outlet. If you cannot plug it in, chances are
you have an older, non-grounded outlet. Contact an electrician to have
the outlet replaced. Do not use an adapter to defeat the grounding.
• Do not place the power cord where it will be walked on. If the power
cord becomes damaged or frayed replace it immediately.
• Do not insert anything into the ventilation slots or openings on the
Printer.
• Only qualified, trained service technicians should attempt to repair
your Printer.
To Next Page
Loading...
Need help?
General
