_______________________________________________________________________
20 Getting Started
2.5.2 Using the Peel and Present Option
The Peel and Present Option allows for on-demand label dispensing and
requires the Internal Rewind Option. To use this option follow the instructions
outlined below.
1. Turn off the Printer and open the Side Access Cover.
2. Follow steps 2, 3, and 4 of Section 2.5 before installing media.
3. Open the Lower Front Panel.
4. Using a phillips screw driver, remove the Tear Bar, invert it (flip it over),
and re-install it as shown in Figure 2-8.
Figure 2-8 Using the Peel and Present Option
NOTE: If media narrower than 4 inches is used, refer to Section 5.3.1 before
loading media.
To Next Page
Loading...
