_______________________________________________________________________
Using Your Printer 37
Temp − this reading is the feedback voltage of the printhead thermistor. At
power up or in an idle condition, this value should be in the range of 060 to
065. A reading of 175 is high and could
decrease the life of the printhead. An average amount of printing will give
readings that range from 070 to 120.
Pot − this reading comes from the darkness potentiometer located on the
front panel board. It will vary from 000 (darkest) to 255 (lightest). Adjust
this value for a midrange value of 128.
TOFA − (Top of Form Adjustment) determines where the first position of
print begins on the label.
RIBN − this value indicates the operation of the ribbon mechanism, this
value will vary.
RWND − this value indicates the operation of the internal rewind
mechanism, this value will vary.
Counter Information − is the values and dates of the absolute and
resettable counters.
Memory Configuration − lists the current size of the 'Internal Module'
RAM in 4K byte blocks, and the 'Scalable Fonts' current cache setup for
scalable font calculations.
To Next Page
Loading...
Need help?
General
