Brady BBP12 - Page 33

BPP12 User Manual
33
Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
To set Black Mark Sensor:
1. Turn off the power switch.
2. Hold the Feed button down, then turn the power switch ON.
3. Release the ONbutton when LED turns green/amber after 5 green blinks.
(Any green/amber will do during the 5 blinks).
The LED color changes as follows:
• Amber → Red (5 blinks) → Amber (5 blinks) → Green (5 blinks) →
Green/Amber (5 blinks) → Red/Amber (5 blinks) → Solid
Green
Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
To set Gap Sensor:
1. Turn off the power switch.
2. Hold the Feed button down, then turn the power switch ON.
3. Release the button when LED turns red/amber after 5 green/amber blinks (any
time during the 5 blinks).
The LED color changes as follows:
• Amber → Red (5 blinks) → Amber (5 blinks) → Green (5 blinks) →
Green/Amber (5 blinks) → Red/Amber (5 blinks) → Solid
Green