Operation
Operation with External Control
10 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
5-2 Operation with External Control
The auto cutters with peripheral interface additionally allow the mode “Cut on
Demand”.
In this operating mode it is necessary to connect a trigger switch or an external
control to the peripheral interface on the cutter.
Note: This operating mode requires that there is a connection between Pin 13
(STA) and Pin 12 (GND) at the peripheral interface (see chapter “Peripheral
Interface”).
The printout of one label or a number of labels with the following cut will be
executed if:
• a print job is available.
• the previous cut has finished.
• the trigger switch, or the external control sends the START signal.
To Next Page
Loading...
