AUTO CUTTER OPERATOR’S MANUAL 11 Edition 04/10
Maintenance
Cleaning
6 Maintenance
6-1 Cleaning
Disconnect the printer from the electrical outlet.
Risk of injury. The cutter blades are sharp.
1. Remove the cutter from the printer.
2. Loosen the screws [2,4] and remove the cover sheets [1,3].
3. Remove dust and paper particles with a soft brush or a vacuum.
4. For cleaning the circular blade it is possible to turn the axle [6] with a
screwdriver for slotted head screws (slot width 7 mm). The rotation angle of
the circular blade is limited to 120°.
5. If it is necessary to turn the circular blade further, loosen the screw [5] about
5 mm. Now the circular blade can be turned completely.
6. Remove all deposits on cutter blades with isopropyl alcohol and a soft cloth.
To Next Page
Loading...
