Introduction
Safety Instructions
2 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
1-2 Safety Instructions
• Disconnect the printer from the electrical outlet before mounting or removing
the cutter.
• The cutter may only be operated when it is mounted on the printer.
• Risk of injury, particularly during maintenance, the cutter blades are sharp.
Rotating knife. Do not touch or put fingers near knife.
• Only trained personnel or service technicians should perform maintenance.
• Unauthorized interference with electronic modules or their software can cause
malfunctions. Other unauthorized work or modifications to the device can also
endanger operational safety.
• Always have service work done in a qualified workshop, where the personnel
have the technical knowledge and tools required to do the necessary work.
• Do not remove warning stickers, as then you and other people cannot be aware
of dangers and may be injured.
To Next Page
Loading...
