AUTO CUTTER OPERATOR’S MANUAL 17 Edition 04/10
Peripheral Interface
Pin Assignment
7 Peripheral Interface
7-1 Pin Assignment
For use in a network environment or with a switch, the auto cutters are equipped
with a peripheral interface to allow control of the cutting process.
The interface has a 15 pin SUB-D connector [1].
Note: The description of system functions is included in this manual. For more
information about user functions (see Programming Manual, Commands x and X.)
Pin Signal Direction System Function User function
1 XSTART Input Start signal
2 XFEH Input External error
3- -
4 - Output - Control bit 3
5 XEDG Output No existing print job Control bit 1
6 XDNB Output Printer is not ready Control bit 2
7 XEGES Output Print of a label has started Control bit 0
8 GND (Output) Ground (0V)
9 RXSTART (Input) Start signal (reverse line)
10 RXFEH (Input) External error (reverse line)
11 - -
12 GND (Output) Ground (0V)
13 STA Input Start signal is active
14 RUEL Output Reverse line
(for all output signals)
15 24P (Output) Operating voltage +24V, 100mA
To Next Page
Loading...
