Brady BP-PR PLUS Series - 7-2-Explanation of Signals

Peripheral Interface
Explanation of Signals
18 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
7-2 Explanation of Signals
Pin
Signal Description
Activation/
Active
State
1 XSTART Start signal
Triggers the start of the print when using the “Cut on
demand“ operating mode,
This signal is checked if there is a connection between signal
STA and ground GND.
Switch on
+24 V
between Pin
1 and Pin 9
2XFEH External error
An error has occurred in an externally-controlled device.
The label print is stopped and the display of the printer shows
the message “External error”.
After the error is corrected, it is possible to press the pause
key and the print job will continue. The last label printed
before the error occurred will be repeated. Pressing the
cancel key will stop the print job and the printer will be reset.
Switch on
+24 V
between Pin
2 and Pin
10
3- -
4- -
5 XEDG No existing print job
There is no print job currently available.
Contact
between
Pin 5 and
Pin 14 is
open
6 XDNB Printer is not ready
An error has occurred on the printer.
The label print is stopped and the details and type of error
can be read from the printer display (‘Ribbon out’; ‘Paper
out’; ‘No label’)
Contact
between
Pin 6 and
Pin 14 is
open
7 XEDST Print of label has started
The printing of a label is indicated with a
20 ms pulse.
Contact
between
Pin 7 and
Pin 14 is
open
8GND Ground ( 0 V )
9 RXSTART Start signal (reverse line)
10 RXFEH External error (reverse line)