AUTO CUTTER OPERATOR’S MANUAL 19 Edition 04/10
Peripheral Interface
Explanation of Signals
11 - -
12 GND Ground ( 0 V )
13 STA Start signal is active
The signal enables the “Cut on demand” operating mode.
In this case the XSTART signal is checked.
With signal STA disabled the cutter is operated in the
standard mode.
Connect Pin
13 with Pin
12 (GND)
14 RUEL Reverse line for all output signals
15 24P Operating voltage +24 V, 100 mA
Output !!! DO NOT connect any external voltage
at Pin 15 !
Pin Signal Description
Activation/
Active
State
To Next Page
Loading...
