Printer Configuration
Mounting the Cutter
6 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
3 Printer Configuration
Once the cutter is connected to the printer, the printer will automatically recognize
the cutter when it is turned on.
The printer can be configured to suit the individual requirements of cut mode in
the Setup menu. When the cutter is installed, the Cutter menu will appear.
Note: For detailed configuration instructions see the printer User Manual.
Note: Print driver version v4.6.21 or higher is recommended.
The cutter requires additional setup in the driver:
1. Select Advanced Setup tab and set the following options:
•
Sensor Type
: Set to material used
•
Cutter:
batch cut or every
To Next Page
Loading...
