AUTO CUTTER OPERATOR’S MANUAL 5 Edition 04/10
Mounting
Mounting the Cutter
Note: For cutter operation with PR PLUS printer series and BBP72 printer, a tear-
off plate or a dispense plate must be mounted on the printer to lead the material
through the blades of the cutter.
3. Insert the pins [3] of the cutter [7] into the holes [4] of the printer.
4. Press the cutter against the printer. That way the plug of the cutter will be
connected to the peripheral port [5] of the printer.
5. Secure the cutter [7] with the screw [6].
To Next Page
Loading...
