AUTO CUTTER OPERATOR’S MANUAL 15 Edition 04/10
Maintenance
Setting Initial State of the Cutter
6-3 Setting Initial State of the Cutter
To operate the cutter correctly after cleaning or after changing the blades the
circular blade [4] and the clock wheel [11] must be adjusted to each other.
1. Unscrew the screws [1], [3] and [6, at the rear].
2. Remove the cover [2].
3. Turn the axle [5] of the circular blade with a screwdriver for slotted head
screws (slot width 7 mm) so that the planar area [8] of the blade axle becomes
parallel to the base plate [7].
To Next Page
Loading...
