Maintenance
Changing the Blades
14 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
8. Remove spring [6] and lineal blade [12].
9. Insert the axle of the (new) lineal blade withe the washer (B) in the bearing
[10] of the mounting plate.
10. Hang in the slack spring [6] to the pins of the mounting plate [9] and the lineal
blade [11].
11. Turn the lineal blade [11] backwards. The spring [6] gets tense.
12. Insert the Axle of the (new) circular blade [2] with the washer (A) in the bearing
[5] of the mounting plate.
13. Place the washer (C) on the axle of the lineal blade.
14. Hang in the slack spring [13] to the pins [12,14] of the lineal blade and the
bearing plate.
15. Push the bearing plate [15] onto the blade axles [2, 11]. The spring [13] gets
tense.
16. Append the bearing plate [15] to the profile [7] using the screws [8].
17. Attend on an accurate position of the bearing plate [15] to the profile [7] of the
cutter and tighten the screws [8].
18. Tighten the set screw [4] at the gear wheel.
19. Lubricate the circular blade (see "6-1: Cleaning" on page 10) and adjust its
initial state (see "6-3: Setting the Initial State of the Cutter" on page 14).
20. Re-mount the cover sheets (see "6-1: Cleaning" on page 10).
56 7 2 8
9 10 11 12 13 14 15
To Next Page
Loading...
