AUTO CUTTER OPERATOR’S MANUAL 7 Edition 04/10
Printer Configuration
Mounting the Cutter
1. For setting the cutter parameters select:
Setup > Machine param. > Cutter .
Notes:
• The values of the setup are basic settings for the actual combination printer/
cutter. After changing the cutter or printer, a re-adjustment may be necessary.
• Changes required for processing different print jobs should be implemented in
additional offsets available in the software.
• The offset values from setup and software are added together for execution.
Parameter Meaning Default
Cutter Configuration of the cutter
> Cut
position
Offset of the cut position relative to the printed
image.
Cut position with the initial offset value of “0”
causes to cut in the middle of the gap between two
labels.
If the cut position value is positive, the media will
be advanced before it is cut, that means the
distance between the cut edge and the rear edge
of the label increases.
0
To Next Page
Loading...
