Printer Configuration
Mounting the Cutter
8 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
2. Select the method for recognizing the material and the method of backfeed
when using cut mode under Setup -> Print parameters .
Parameter Meaning Default
Label
sensor
Method for detecting the starting end of the label.
Gap Sensor: Detection using changes in the
transparency between the label and label gap.
Bottom-Reflect: Detection using reflex marks on
the bottom of the medium.
Continuos media: Synchronization of the
paper feed when using endless media in cutting
mode.
X After loading media press the feed key to
recognize a short feed and synchronization cut.
Gap
sensor
Backfeed Method for backfeeding the material.
Backfeeding is necessary in the cutting mode
since the front edge of a second section already
passes the print line when the first label is moved
to the cut position.
always: Backfeeding occurs independently of
print contents.
smart: Backfeeding only occurs when the print
contents of the next section is not yet fully
prepared when cutting the current section.
Otherwise, the second section is pushed on and
completed after removal of the first section
without backfeeding.
smart
To Next Page
Loading...
