Maintenance
Cleaning
12 Edition 04/10 AUTO CUTTER OPERATOR’S MANUAL
Note: When cutting through the label material instead of the label gap, remains of
adhesive may accumulate on the blades. If operating in backfeed mode, such
remains of adhesive may be deposited on the drive roller as well.
Clean the drive roller (see Printer Operator’s Manual) and the cutter blades often.
7. Grease the cylindrical area [7] of the circular blade [8] with an all-around high
quality grease. For that hold a greased brush on the cylindrical area and turn
the axle [6] with a screwdriver for slotted head screws (slot width 7 mm).
During the turning the area is all-around greased.
8. If the screw [5] was loosened during cleaning, adjust the initial state of the
cutter (see "6-3: Setting Initial State of the Cutter" on page 14) .
9. Re-mount the cover sheet [1] using the screws M4x6 [2] and cover sheet [3]
using the screws M4x10 [4].
To Next Page
Loading...
