16 Tjekliste for sikkerhedstjek USA.fm • Page 40Bale press X-series
Defective OK
Check cable and socket (all models)
Visually check the supply cable and socket. There must be no
cracks or other defects, etc.
Check the repair switch (E) (all models)
Set the repair switch (E) to "0" or OFF.
Then press the green start button (B).
The baler must not be able to start.
Check that the repair switch (E) can be locked in this position.
Set the repair switch (E) back to "1" or "ON".
Reset the baler with a single push of the green start button
(B).
Check the emergency stop (A) (all models)
Doors (F) and (G) must be closed.
(On AD models only door (G) must be closed).
Activate the emergency stop button (A).
Then press the green start button (B).
The baler must not be able to start.
Deactivate the emergency stop button (A).
Reset the baler with a single push of the green start button
(B), start the baler by pushing the green start button (B)
again.
Activate the emergency stop button (A).
The baler must stop immediately.
Deactivate the emergency stop button (A).
Reset the baler with a single push of the green start button
(B).
Check the two-hand control (C) and (D) (all models)
Press on the finish indicator button (C) so the platen (H) goes
to the bottom position.
Open door (G) so that two-hand operation (C) and (D) is
activated.
With model X10 open the doors (F) and (G) so that the two-
hand operation (C) and (D) is activated.
First press the finish indicator button (C), then press button
(D).
The baler must not eject the bale.
Press buttons (C) and (D) simultaneously and constantly
within a time interval of a half second.
The baler should start to eject the bale.
Close door (G). With model X10, close doors (F) and (G).
To Next Page
Loading...