Branson 2100 - 2> Disassembling and Assembling; Brake Pedal

BRAKE
KUKJE MACHINERY CO., LTD.
116
5. CHECKING, DISASSEMBLING AND SERVICING
<2> DISASSEMBLING AND ASSEMBLING
1) Brake Pedal
*. PART NAME
1) External snap ring 2) Collar
3) Return spring 4) Brake pedal RH
5) Brake pedal LH 6) Pin fastener
7) Return spring 8) Clutch pedal
9) Brake pedal shaft 10) Spring lock pin
11) Pin fastener 12) Brake rod
13) Parking brake lever 14) Pin fastener
1. Remove the spring lock pin(10), pin fastener(14)
of brake rod(12) and pull out the brake rod(12).
2. Remove the return spring(3),(7).
3. Remove the external snap ring(1) at the end of
the brake pedal shaft(9).
4. Remove the pin fastener(6) of the brake pedal
LH(5)
5. Remove the pin fastener(11) of the clutch
pedal(8).
6. Pull the right and left brake pedals from the
brake pedal shaft(9).
7. Tap out the brake pedal shaft(9) to the left, and
remove it with the clutch pedal(8).
▷ Reassembling
9 Apply grease to the brake pedal shaft.
9 When inserting the pin fastener, face its split in
the direction at right angle to the brake pedal
shaft.
(14)