CLUTCH
KUKJE MACHINERY CO., LTD.
39
4. CHECKING, DISASSEMBLEING AND SERVICING
<1> CHECKING AND ADJUSTING
< Checking clutch pedal free travel >
When checking, park the tractor on flat ground,
apply the parking brake, stop the engine and
remove the key.
1. After adjusting it, measure total stroke “A”
between stopper bolt(1) and clutch housing(4).
2. If the measurement is not within the factory
specifications, adjust it with the clutch pedal
stopper bolt(1).
3. And at same the time, adjust the clearance “B”
between safety switch(5) and clutch rod(6).
▶ NOTE
1) After adjustment, secure the stopper bolt with
the lock nut(3).
Clutch pedal free travel “L” on top of
clutch pedal.
25 to 35 mm
0.98 to 1.38 in.
Clutch pedal total stroke “A”
Factory
spec.
7.0 to 9.0 mm
0.31 to 0.35 in.
Clearance “B”
Factory
spec.
1.5 to 2.5 mm
0.06 to 0.08 in.
*. PART NAME
1) Stopper bolt
2) Clutch pedal rod
3) Lock nut for stopper bolt
4) Clutch housing
5) Safety switch
6) Clutch rod
L
To Next Page
Loading...
