GENERAL
KUKJE MACHINERY CO., LTD.
22
< Checking wheel mounting screws and nuts
tightening torque >
▶ Never operate tractor with a loose rim, wheel,
or axle.
▶ Any time bolts and nuts are loosened,
retighten to specified torque.
▶ Check all bolts and nuts frequently
and keep them tight.
1. Check wheel bolts and nuts regularly especially
when new. If there are loosened, tighten as
follows.
Front wheel mounting
bolt
77 to 90 Nm
7.9 to 9.2 kgfm
57.2 to 66.5 ft-lbs
Tightening
torque
Rear wheel mounting
Nut / bolt
108 to 125 Nm
11.0 to 12.8 kgfm
80 to 93 ft-lbs
*. PART NAME
1) Front wheel mounting bolt
2) Rear wheel mounting bolt
3) Rear wheel mounting nut
<4> CHECK POINTS OF EVERY 100 HOURS
< Changing engine oil >
-. Reference the page. 14.
< Checking clutch pedal free travel >
-. Reference the page. 18.
< Checking battery condition >
▶ Never remove the vent plugs
while the engine is running.
7. DISASSEMBLING AND SERVICING
(2)
(3)
To Next Page
Loading...
