Branson 2100 - Disassembling Rear Axle Case

BRAKE
KUKJE MACHINERY CO., LTD.
119
5. CHECKING, DISASSEMBLING AND SERVICING
3) Disassembling Rear Axle Case
*. PART NAME
1) Spring 2) Differential lock shift fork
3) Differential lock clutch
4) 57T Gear 5) Bearing
6) External snap ring 7) Rear axle
< Differential lock shift fork, differential lock
clutch, 57T gear and rear axle >
1. Remove the spring(1).
2. Draw out the differential lock shift fork(2) and
differential lock clutch(3)
3. Remove the external snap ring(6) and remove
the bearing(5).
4. Draw out the 57T gear(4) from the rear axle(7).
5. Tap out the rear axle(7) to the outside of the axle
case.
< Brake assembly >
1. Remove the internal snap ring(1).
2. Remove the brake shaft(2) with brake discs.
▷ Reassembling
9 When installing the internal snap ring(1) to rear
axle case(3) follow direction as shown in the
figure.
9 When installing the bearing holder(4) to the rear
axle case(3), do not forget to install the straight
pin(5).
< Brake discs and friction plate >
1. Remove the external snap ring(1), and remove
the brake discs and friction plate.
▷ Reference
1. Remove the cam plate and balls.
2. Remove the external snap ring and pull out the
brake cam lever.
▷ Reassembling
9 Install the brake discs with their holes(2) align at
less than 1/3 of the total hole area.
*. PART NAME
1) Internal snap ring 2) Brake shaft
3) Rear axle case 4) Bearing holder
5) Straight pin
*. PART NAME
1) External snap ring 2) Hole
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(2)
(4)
(1)
(3)
(5)
(1)
(1)
(1)
(2)