Branson 2100 - Disassembling Clutch Housing

TRANSMISSION
KUKJE MACHINERY CO., LTD.
87
5. CHECKING, DISASSEMBLING AND SERVICING
<3> DISASSEMBLING AND ASSEMBLING
1) Disassembling Clutch Housing
*. PART NAME
1) Clutch rod
2) Clutch release fork
3) Release bearing
4) Set spring
*. PART NAME
1) Clutch housing rear cover
A) HST Type B) Manual transmission type
< Clutch rod and clutch release fork >
1. Remove the external snap ring at the end of
clutch rod.
2. Draw out the clutch rod(1) and remove the
clutch release fork(2).
3. Take out the release hub with release bearing(3).
▷ Reassembling
9 Set the clutch release fork and release hub with
set spring(4) in the correct direction.
< Clutch housing rear cover >
1. Remove the clutch housing rear cover(1).
▷ Reassembling
9 Apply the gasket to the joint face of clutch
housing and rear cover(1).
< Clutch shaft and others >
1. Pull out the clutch shaft assembly(1).
2. Pull out the 2
nd
gear shaft, front assembly(2)
(HST Type).
3. Pull out the 2
nd
shaft, front assembly(3)
(Manual transmission type).
4. Pull out the 3
rd
shaft, front assembly(4)
(HST Type).
▷ Reassembling
9 Apply small amount of the grease to the oil
seal(5).
*. PART NAME
1) Clutch shaft assembly
2) 2
nd
gear shaft, front assembly
3) 2
nd
shaft, front assembly 4) 3
rd
shaft, front assembly
5) Oil seal
A) HST Type B) Manual transmission type
(1)
(2)
(3)
(4)
(A)
(B)
(1)
(1)
(A)
(B)
(1)
(2)
(4)
(5)
(1)
(3)
(5)