TRANSMISSION
KUKJE MACHINERY CO., LTD.
89
5. CHECKING, DISASSEMBLING AND SERVICING
3) Disassembling Transmission Case (HST Type)
*. PART NAME
1) Front wheel drive lever
2) Differential lock pedal support
3) Top link bracket 4) Hydraulic cylinder
5) Rear axle case 6) Drawbar frame
7) PTO shift lever 8) Range gear shift lever
< Separating hydraulic cylinder, rear axle cases and
others >
1. Remove the external snap ring and remove the
PTO shift lever(7) and range gear shift lever(8).
2. Remove the front wheel driver lever(1).
3. Remove the differential lock pedal support(2).
4. Remove the top link bracket(3) and remove the
hydraulic cylinder(4).
5. Remove the rear axle case(5) and drawbar
frame(6).
▷ Reassembling
1. Apply gasket to joint face of the differential case
to hydraulic cylinder and rear axle.
Hydraulic cylinder
mounting screw
and nut
48.1 to 55.9 Nm
4.9 to 5.7 kgfm
35.4 to 41.2 ft-lbs
Tightening
torque
Rear axle case
mounting screw
48.1 to 55.9 Nm
4.9 to 5.7 kgfm
35.4 to 41.2 ft-lbs
< Separating mid-PTO case, transmission case and
differential case >
1. Remove the mid-PTO case mounting screws and
separate the mid-PTO case(3) and transmission
case(1).
2. Remove the transmission case mounting screws
and nuts and separate the differential case(2)
and transmission case(1).
▷ Reassembling
9 Apply gasket to joint face of the transmission
case to differential case and mid-PTO case to
transmission case.
Tightening
torque
Transmission case
mounting screw
and nut
48.1 to 55.9 Nm
4.9 to 5.7 kgfm
38.4 to 41.2 ft-lbs
*. PART NAME
1) Transmission case 2) Differential case
3) Mid-PTO case
To Next Page
Loading...
