Branson 2100 - Starting System

ELECTRIC SYSTEM
KUKJE MACHINERY CO., LTD.
163
STARTING SYSTEM
Symptom Probable Cause Solution Reference
Battery discharged or defective Recharge or
Replace
Slow blow fuse blown Repair or Replace
Safety switch improperly adjusted or
defective
Repair or replace
Wiring harness disconnected or improperly
connected (between main switch 50 terminal
and operator presence controller, between
main switch 50 terminal and starter relay,
between safety switches and operator
presence controller, between battery positive
terminal and starter motor)
Repair or Replace
Operator presence controller defective Replace
Starter relay defective Replace
Starter motor defective Repair or Replace
Starter Motor
Does Not
Operate
Main switch defective Replace
Battery discharged or defective Recharge or
replace
Slow blow fuse blown Replace
Wiring harness disconnected or improperly
connected (between main switch 19 terminal
and pre-heat indicator, between pre-heat
indicator and glow plugs)
Repair or Replace
Main switch defective Replace
Pre-heat
indicator Lamp
Does Not Light
When Main
Switch is in
Pre-heat
Position
Pre-heat indicator defective Replace
7. TROUBLE SHOOTING