Please read before installing or using the equipment.
1. Be sure the welder is unplugged and the power switch is in the OFF
position before making any electrical connections.
2. To prevent the possibility of an electrical shock, always plug the
welder into a grounded power source.
3. If you wish to use a J911 cable, you must first have signed a Branson
Product Liability Agreement.
4. To prevent personal injury or damage to the equipment or workpiece
being welded, always hold the welder in place before releasing the
column clamps. This procedure may require two people.
5. When setting up and operating the welder, observe the following
precautions:
a.
High voltage is present. Do not operate with covers open or
removed.
b.
Do not touch a vibrating horn.
c.
Large plastic workpieces may vibrate within the audible
frequency range when welded. If this occurs, use hearing
protectors to prevent possible injury. (For further information,
refer to Appendix F "Manufacturers of Hearing Protectors.")
d.
Do not press the 'PEST switch when the converter is removed
from the welder.
6. Ensure that the cover is closed with door screws secured and that no
one is in contact with the horn when you press TEST. Automated
systems users should turn off indexing equipment for this test.
7. Be sure the welder is unplugged before setting the DIP switches.
Warnings
To Next Page
Loading...
