Branson F36r - Page 356

6
-
78
42hW-201601
CHAPTER 6 HYDRAULIC SYSTEM 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
HYDRAULIC CYLINDER INSTALLATION STANDARD
1. Keep all hydraulic components clean and remove
any foreign material and dust from them before
their installation.
1
2
K25W6A46A
2. When installing the O-ring (1) and backup ring
(2) to the piston, install them in the correct
direction.(Applytransmissionuidtothembefore
installation.)
K25W6A47A
3. Check if the O-rings for the hydraulic cylinder
and hydraulic cylinder cover are missing or
damaged. Apply grease on them before their
installation.

aNJIFP
7LJKWHQLQJWRUTXH
7LJKWHQLQJWRUTXH
aNJIFP

K25W6A48A
4. When installing the safety valve (1) and lowering
speed control valve (2), check if their O-rings are
missing or damaged. Also, apply grease on them
before installation.
7LJKWHQLQJWRUTXH
aNJIFP
K25W6A49A
5. When installing the lifting/lowering control valve,
check if its O-ring is missing or damaged. Also,
apply grease on it before installation. Also,
tightenthemountingbolttothespeciedtorque.
K25W6A50A