Branson F36r - Page 358

6
-
80
42hW-201601
CHAPTER 6 HYDRAULIC SYSTEM 3015R(h)/3515R(h)/4015R(h)/F36R(h)/F42R(h) TRACTOR
NOTE
K25W6A57A
12. When installing the return spring, set its longer
section to the front.
PP
K25W6A58A
13. Setting length of draft control rod: 25 mm (distance
between rod end and bracket)
7LJKWHQLQJWRUTXH
aNJIFP
7LJKWHQLQJWRUTXH
aNJIFP
7LJKWHQLQJWRUTXH
aNJIFP
7LJKWHQLQJWRUTXH
aNJIFP
K25W6A59A
14.Tighten the high-pressure pipe to the specied
torque and install the cam correctly according
to the specification specif ied in the figure.
(When installing the cam assembly, turn it
counterclockwise for 5 mm from the end of the
long hole.)
7LJKWHQLQJWRUTXH
aNJIFP
7LJKWHQLQJWRUTXH
aNJIFP
2
1
K25W6A60A
15. When installing the rear SCV, make sure that its
O-ring is not missing or damaged.
16. When installing the SCV, tighten its nut to the
speciedtorque(200-250kgf.cm).
17. When installing the quick coupler (1) and joint (2),
wrap them with seal tape.
How to adjust draft sensitivity
1) High sensitivity (shallow): Adjust the length
of the mounting nut to 25 mm or longer.
2) Low sensitivity (deep): Adjust the length
of the mounting nut to 25 mm or shorter.
•
Check installing
direction
POSITION/DRAFT CONTROL TYPE
OPTIONAL