Breitling EXOSPACE B55 - Introducing the Distance for the Tachymeter; Rereading Intermediate Times; Recovery of Times; Synchronizing the Seconds Hand

4140
• ConrmbypressingP2;therstdigitofthedistancevaluewillash.
• Selecttheunits,thetensandthenthehundredsforthedistancebyturningthe
crown, confirming each time by pressing P2.
• Pressthecrownbacktoneutralposition1.
g) Rereading intermediate times
Rereading of intermediate times is achieved by successive pressing of P2 with
the display of
SPLIT01 to SPLITxx intermediate times memorized.
h) Recovery of times
If the watch is connected to a smartphone, using the application on the latter
it is possible to recover information on times recorded.
i) Synchronizing the seconds hand
If the seconds hand does not position itself exactly on 0 in
CHR ADD mode, proceed
as follows:
• Pullthecrownintoposition2.
• PressP1toactivatesynchronizationofthehand(
SyNCHRo).
• Turnthecrowntorepositionthehandon0.
• Pressthecrownintoneutralposition1.
f) Introducing the distance for the tachymeter
To enable the tachymeter to calculate the speed correctly, the distance corresponding
to the time recorded must be introduced. This setting is done as follows:
• With
CHR ADD mode stopped without displaying the speed, pull the crown into
position 2; the upper screen will display
DIST, followed by 3 digits (for the
distance), followed by one to three letters (for the distance unit); the distance
unit flashes.
• Selectthedistanceunitbyturningthecrown–seegure2:
Distance unit Corresponding speed unit
M (meter) M/S (meters per second)
KM (kilometer) KM/H (kilometers per hour)
FT (foot FT/S (feet per second)
yD (yard) yD/S (yards per second)
MI (mile) MPH (miles per hour)
NMI (nautical mile) KNoT (knots)
Figure 2