Breitling EXOSPACE B55 - Battery Changing Status; Deep Sleep Mode; Soft Sleep Mode

6160
• Do not forget to push the crown back into neutral position 1.
To reactivate the watch, it must be charged using the cable supplied, and a com-
plete reinitialization must be performed, as described in chapter 3.
b)
SoFT SLEEP mode
The
SoFT SLEEP mode allows the watch to be put in a state of active standby,
equivalent to the mode adopted by the watch when the remaining battery life is
too low (level 3 – chapter 2.b). This function is useful in the event of the watch not
being used for a short time and when one wishes to maintain a maximum of the
battery life as well as the settings and the correct time. The setting procedure for
the active standby state is as follows:
• Selectthe
BATTERy function by turning the crown.
• Pullthecrownintoposition2.Theupperscreenwilldisplay
DEEP SLEEP or SoFT
SLEEP
. Select SoFT SLEEP by turning the crown.
• GiveP2alongpresstoconrmstandbymode.Thehandswill“park”.Oncethe
procedure is terminated, the display turns off but the basic time of the watch
remains active. At this point, the pushpieces and crown are completely inactive.
• Donotforgettopushthecrownbacktoneutralposition1.
In order to reactivate the watch, it must be charged using the cable provided.
Please note that the battery life of the watch depends on the frequency with
which notifications appear: the more notifications there are, the less battery life
the watch will have.
18. BATTERY CHARGING STATUS (
BATxx%)
At any time, the BAT function shows the status of the battery charge in percentage,
by indicating
BATxx% on the upper screen. Charging is recommended when the
charge is less than 15-20%. When the battery reaches this level, the seconds hand
advances in 4-second increments.
a)
DEEP SLEEP mode
DEEP SLEEP mode allows the battery to be disconnected from the watch’s electronic
circuits and thus to preserve its performance (capacity). This function is useful if the
watch is not used over a relatively long period. This operation also enables a reset
of the watch. The manual sleep mode setting procedure is as follows:
• Select the
BATTERy function by turning the crown.
• Pullthecrowninto position 2.Theupperscreendisplays
DEEP SLEEP or SoFT
SLEEP
. Select DEEP SLEEP by turning the crown.
• Give P1 a long press to conrm the extended standby. The hands “park”
immediately. Once the procedure is finished, the display turns off and the
electronics are disconnected. Following this, the pushpieces and crown are
completely inactive.