Breitling EXOSPACE B55 - Watch Configuration and Settings

5150
• Choose a letter by turning the crown; validate it by pressing P2 and the second
line will flash. Repeat the operation for the three other characters.
•
The upper screen will then display the landing airport, B xx To followed by “----“
while the first line flashes and the lower screen displays ICAo.
• SelectaletterbyturningthecrownandvalidateitbypressingP2.Thesecond
line will flash. Repeat the operation for the other three characters.
• ConrmthesettingbypressingP2and/orpushingthecrownbackonceagain
into neutral position 1.
f) Deleting one or more blocks
•
To delete the active block, press on P2 for a long time when the crown is in
neutral position 1
(RESET).
• Todeletealltheblocksatonce,proceedasfollows:
–
Pull the crown into position 2.
– Press P2 for a long time (EMPTy)
– Press the crown back into neutral position 1.
g) Recovering times
If the watch is connected to the smartphone, various flight data can be recovered
using the smartphone application.
d) Information regarding the landing airport on the upper screen with
Bxx To,
followed by the 4 character ICAO code (will display “
----“ if nothing has been
introduced); the lower screen displays
ICAo.
e) The take-off time on the lower screen with
BxxTKoF displayed on the upper
screen.
f) The landing time on the lower screen with
Bxx LDG showing on the upper screen.
g) The flight time on the lower screen with
BxxFLyT showing on the upper screen.
h) And back to the display
Bxx ADD on the upper screen.
If the memory contains several blocks, P2 must be pressed successively in order to
see the parameters of the ensuing blocks. The time of the last block is then auto-
matically displayed with
Bxx ADD on the upper screen.
e) Manual introduction of ICAO codes for airports
ICAO codes for take-off and landing airports are introduced through the appli-
cation, as long as the watch is connected to the smartphone. It is nevertheless
possible to introduce these codes manually as follows:
•
While rereading a block (see chapter 12.d), pull the crown into position 2, and
the upper screen will initially display the take-off airport,
B xx FRoM followed by
“
---- “ with the first line flashing; while the lower screen displays ICAo.