Breitling EXOSPACE B55 - Lighting, Display, and Tone Options

5554
• Pullthecrownintoposition2(SET TMR) and turning the crown, adjust the hours
(
HoUR), minutes (MINUTE) and seconds (SECoND) up to a maximum of 99 hours,
59 minutes and 59 seconds, confirming it each time by pressing P2.
•
Adjust the type of alarm signal desired (ALARM SIGNAL display): BUZZER (sound
alarm),
VIBRATE (vibrating, silent alarm) or BoTH (both together) by turning
the crown and confirming by pressing P2.
• Pressthecrownbackintoneutralposition1.
b) Use
• PressingP1willstartthetimer(
TMR RUN).
• PressingP1asecondtimewillstopit(
TMRSToP), while pressing again will restart
it (
TMR RUN).
•
When the timer is working, a long press on P2 will reset the original settings
(
RESET).
During the last 3 minutes, the seconds hand counts counter-clockwise the seconds
and a beep is emitted every second for the final 10 seconds. At 0, an alarm sounds
for 20 seconds, with a 10-second reminder after 1 minute. The upper screen flashes
TMR0. The alarm can be stopped by pressing one of the two pushpieces or on
the crown.
• Pullthecrownintoposition2(theupperscreendisplays
SETALCU)
• Set the number of days (
DAy), hours (HoUR), minutes (MINUTE) and seconds
(
SECoND), up to 99 days, 23 hours, 59 minutes and 59 seconds, by turning the
crown and confirming each time by pressing P2.
• Set the type of alarm signal desired (
ALARM SIGNAL display): BUZZER (sound
alarm),
VIBRATE (vibrating, silent alarm) or BoTH (both together) by turning the
crown and confirming by pressing P2.
• Decideifyouwishthealarmtoberecurrent(willringevery24hoursinfuture)
or not (
REP oN or REP oFF), by turning the crown and confirming by pressing P2.
• Pressthecrownbackintotheneutralposition1.
b) Use
Pressing P1 activates or switches off the alarm (ALCU oN or ALCUoFF).
The alarm sounds for 20 seconds, with a 10 second reminder after 2 minutes. The
upper screen displays
ALCU by flashing (alternately with the DAy ( S ) if different from
0). The alarm can be stopped by pressing one of the two pushpieces or the crown.
15. COUNTDOWN (TIMER)
a) Setting (
SET TMR)
• Selectthe
TIMER function by turning the crown.