BREWART BREWFLO - Operation; Inserting a keg; Inserting the beer line

 Note
Use only BrewArt 5 Litre kegs.
Your BrewFlo will chill a warm
keg in approximately 10 hours
so for immediate use we
suggest you pre-chill your
kegs in your refrigerator.
BREWART BY COOPERS
10
Operation
1. Inserting a keg
k Only use BrewArt kegs that
have fully completed their
secondary fermentation. If
unsure, visit brewart.com/101
k Open the lid and insert
a BrewArt keg.
2. Inserting the beer line
k Release the beer line holder from
the font by pressing the release
button at the base of the font
connection – see Diagram C.
k Unclip the beer line holder
and feed the open end of the
beer line all of the way through
the hole – see Diagram D.
k Pull the font handle forward,
and then feed the open end of
the beer line into the font until
it stops (approximately 3cm) –
see Diagram E.
k Release the font handle.
k Fit the beer line and beer line
holder back into place.
 Note
The beer line must be installed in the
Font before connecting it to a Keg.
C
D
E