BREWART BREWFLO - Empty keg

BREWART BY COOPERS
14
 Note
It is important to keep a partially
used keg pressurised to maintain
carbonation levels in your beer.
If you accidentally depressurise
the keg simply use the BrewFlo
to pressurise it again.
Empty keg
k To depressurise the keg, leave
the air line connecter in the keg.
Release the air line by pressing the
white release button, and pulling
the airline away from the black
connector – see Diagram K.
k Wait for air to completely
expel from the keg.
k Return the elbow connector
to the air line.
k Disconnect the beer line by pressing
the orange release button on the
Beer Line keg valve. The connector
should release from the keg.
k Release the beer line holder
by pressing the button and
unclip it from the beer font.
k Raise the beer line and pull the
font handle forward to drain
any residual beer from the
beer line – see Diagram L.
k Pull the beer font handle forward
and pull the beer line out from
the beer font and beer line holder
and safely dispose beer line.
k Remove keg.
k Unscrew the keg cap and
remove foil keg liner.
k Safely dispose of the foil
keg liner and beer line.
k Clean and rinse the Cap assembly
with clean water and allow to air dry
taking care not to lose small parts
when disassembling the valves.
K
L