BREWART BREWFLO - Connecting the lines; Powering up

BREWFLO INSTRUCTIONS
11
3. Connecting the lines
k Connect the beer line to the keg
by inserting its connector to
the orange keg valve. Press the
connector until it clicks into place,
ensure beer line is straight and
free of kinks – see Diagram F.
k Connect the air line to the keg by
inserting the connector to the black
keg valve. Press the connector until
it clicks into place – see Diagram G.
k Close the lid.
 Note
It is best to wait until your keg is
chilled before connecting air and
beer lines.
4. Powering up
k Plug the power cord found
at the rear of your BrewFlo
into a power point and turn
on at the power point.
k Set power switch at the back
of your BrewFlo to ON.
k The display screen will light up
and momentarily display all
LCD screen content, the current
soware version will display, and
then it will enter standby mode.
k On the control panel press
the  button to turn ON.
F
G