BREWART BREWFLO - Changing kegs; Mid keg

BREWFLO INSTRUCTIONS
13
Changing kegs
Mid keg
 Note
You can remove a partially used
keg and replace it with another
keg at any time.
k Disconnect the air line by
pressing the white release button
on the airline keg valve. The
black elbow connector should
release – see Diagram I.
k Disconnect the beer line by
pressing the orange release
button on the Beer keg valve.
The connector should release.
 Note
Place a cloth or paper towel around
the beer valve to catch the small
beer squirt when disconnecting
from the keg beer valve.
k Release the beer line holder
by pressing the button and
unclip it from the beer font.
k Raise the beer line and pull the
font handle forward to drain
any residual beer from the
beer line – see Diagram J.
k Pull the beer font handle
forward and pull the beer line
out from the beer font.
k Remove keg.
k Rinse any beer in the keg beer
valve with clean water.
k Replace keg. Refer to
Inserting a keg.
I
J