17
Error codes
Code Description User Action
E1 Load cell error.
The load cell
determines the
weight of the keg and
therefore the volume
of beer remaining.
Power o the unit at the wall for one minute
and try again, if the problem persists please
visit brewart.com/101 where you will find
FAQs and trouble shooting information.
If this does not help resolve your issue,
please contact customer service.
E2 Temperature
sensor error.
Power o the unit at the wall for one minute
and try again, if the problem persists please
visit brewart.com/101 where you will find
FAQs and trouble shooting information.
If this does not help resolve your issue,
please contact customer service.
E3 Air leak.
Keg failed to
pressurize within 10
minutes time limit.
Check the following:
k Connectors clicked together properly
k Keg collar is securely screwed down
Please visit brewart.com/101 where you will find
FAQs and trouble shooting information. If this
does not help resolve your issue, please contact
customer service.
E4 Pump overload.
An Air Pump
overload has been
detected, the air
pump has been
stopped for safety.
To reset this error press the front panel
button to put the unit in standby, clear error
and reset unit. Aer a few seconds press
again. If the problem persists, please
visit brewart.com/101 where you will find
FAQs and trouble shooting information.
If this does not help resolve your issue,
please contact customer service.
To Next Page
Loading...